Technical specifications for IC660EBR100
Brand GE Intelligent Platform /GE Fanuc
Series Genius I-O
Part number IC660EBR100A
Product Type Electronic Assembly
Operating temperature 0 to 60 degrees Celsius
Storage temperature -40 to 100 degrees Celsius
Non-condensing humidity 5% to 95%
Frequency 47 to 63 Hz
Operating voltage 115 VAC /93 to 132 VAC or 230 VAC /185 to 265 VAC
87 mA at 115 V AC
Power voltage drop time 1 cycle
Heat dissipation 10.1 watts, 16 outputs
The recommended minimum load is 10 MA
Relay type Fixed coil moving armature
Maximum initial contact resistance 100 milliohm
The IC660EBR100 electronic assembly block is manufactured by GE Intelligent Platforms/GE Fanuc Automation. It belongs to the Genius I/O series and has 16 circuit relay outputs divided into 4 separate groups of 4 outputs each, with an LED on each circuit with a separate relay coil state. The electronic assembly weighs about 1.8 kg and measures 8.83 x 3.50 x 3.94 inches. Its environmental specifications are an operating temperature of 0 to 60 degrees Celsius, and a storage temperature range of -40 to 100 degrees Celsius, with a relative humidity range of 5 to 95 percent and no condensation. The IC660EBR100 Electronics assembly block has a nominal voltage rating of 115 volts AC with an operating voltage range of 93 to 132 volts AC, or a rated voltage of 230 volts AC with an operating voltage of 185 to 265 volts AC.
The IC660EBR100 Electronics assembly block has a power current requirement of 87 MA at 115 volts AC and a power supply voltage drop time of 1 cycle. It has a heat dissipation rating of up to 10.1 watts and 16 outputs open. The GE Fanuc IC660EBR100 electronic component block has a maximum output current of 2 amps per circuit and a maximum switching power of 60 watts or 125 volt-amps. Each circuit has a surge current of 2 amps (maximum) and an output off state leakage current of 0.1 mA. For inductive loads, it has a full-force switching frequency of 20 cycles in 60 seconds or an output opening delay time of 5 microseconds. The output voltage range of the IC660EBR100 Electronics assembly block is 5 to 250 volts AC or 5 to 220 volts DC with a minimum recommended load of 10 MA. It also has a fixed coil moving armature relay type.
