Technical specifications for IC693MDL240
Brand GE Intelligent Platform /GE Fanuc
Series Series 90-30
Manufacturer GE Fanuc
Part number IC693MDL240
Product description Discrete input module
Number of channels 16 (16)
Input signal range 0-132 volts AC
Product type input module
Nominal input voltage 0-120 volts AC
Volts 120 volts alternating current
Input frequency 47-63 Hz
Input 16
The input current is 12mA per channel
The frequency is 50/60 Hertz
Current consumption is 90 MA
Input current at rated speed 12 mA
The IC930MDL240 is a discrete input module in the 90-30 series product family. The module was previously manufactured by GE Fanuc Automation, but was recently acquired by Emerson Automation. This module is a universal input module that occupies a single I/O slot on the CPU, I/O expansion, or remote I/O baseboard. The IC930MDL240 operates in an input voltage range of 0-132 VAC with a frequency of 50/60 Hz, while the nominal voltage is 120 VAC and the nominal input current is 12 mA. The module can be used to detect state changes in binary operating field devices such as switches, buttons, auxiliary contacts, and other similar operating devices. The IC930MDL240 comes with a set of input channels with an isolation rating of 1500 VAC (rms) between the field side and the logical side. It has an on-state voltage range of 74-132 VAC and an on-state current of 6 mA, while a Off state voltage of 0-20 VAC and a off state current of 2.2 mA. The maximum on-off response time for each channel is 30 ms and the maximum turn-off response time is 45 ms. The current consumption of the module is 90 mA @ 5VDC bus voltage. There is no limit to the number of IC930MDL240 installations. Install as many devices as needed. The only limitation is the I/O capacity of the host controller and the number of extended or remote I/O backboards it supports. The programming software used to configure the IC930MDL240 varies depending on the firmware version or the version of the host controller. A package that can be used to parameterize this module to the LogicMaster 90-30, VersaPro, or Proficy Machine Edition packages.
The GE Fanuc IC693MDL240 input module is part of the Series 90-30 GE PLC product line. It has a rated voltage of 120 volts AC, and 16 input points share a common power output terminal. These 16 circuits include a capacitor and a resistor, which are reactance inputs. When the current flows through the input point, the logic reading in the input status table is logic 1 (%I). It has functional input modules that are compatible with various input devices. For example, operators can use it with a limit button, switch, or electronic proximity switch. The GE Fanuc IC693MDL240 module can be used with field devices when powered by the user. The IC693MDL240 module requires AC power because it cannot operate on direct current. The module has LED indicators at the top to show the ON and OFF status of each input point. The module also has 2 horizontal row leds with 8 green leds in each row. The first row of leds is labeled A1 to A8, representing output points 1 to 8 respectively, and the bottom row is labeled B1 to B8, representing points 9 to 16. The IC693MDL240 input module has hinged doors. There is also a plug-in, located between the module's inner door and outer door surfaces. When this door is closed, the inner surface contains information about the circuit wiring. The inner surface records circuit identification information. The module is a valuable addition to GE series 90-30 programmable logic controller systems and can be installed on any 5-slot or 10-slot I/O baseboard.
