Product number: DS200PTBAG1A
Manufacturer: General Electric
Series: Mark V
Product type: Protection terminal module
The GE terminal board DS200PTBAG1A has two terminals, each of which can hold 72 signal cables. It also contains three 10-pin connectors. The ids of the 10-pin connectors are JJR, JJT, and JJS. It also contains terminals for 6 signal lines. In terms of its dimensions, the GE terminal board DS200PTBAG1A is 3 inches tall and 11.5 inches wide, with 1 hole in each corner for attaching the board to the board rack inside the drive. Because of the large number of signal wires and ribbon cables connected to the board, it is best practice to map where the signal wires are connected on the board and plan to connect the wires to the same connectors on the replacement board. Failure to connect the signal line to the same terminal will increase driver downtime when connecting the signal line to the correct terminal, which can inconvenience field operations and reduce productivity. To prevent this from happening, check the old board on the driver while all the signals and ribbon cables are still connected together. Mark the signal lines connecting them with the terminal ID. The ID of one terminal is TB1 and the ID of the other terminal is TB2. To identify a specific terminal, use the numeric ID of the terminal. For example, TB1 27 is terminal 27 on the TB1 wiring terminal. TB2 70 is the terminal 70 on the TB2 wiring terminal. You may find it helpful to create a label for marking the ID.
This DS200PTBAG1A protected terminal board uses some customizable hardware in its components, the most obvious of which is its manually removable hardware jumper. The jumper is included in the component of this DS200PTBAG1A protection terminal module because it controls the audible alarms or horns that are standard with GE products.
To mute the horn contained in this PTBA abbreviated terminal module assembly, the DS200PTBAG1A board administrator must completely remove the above hardware jumpers. The DS200PTBAG1A protective terminal board plays a vital role in the specification function of the related Mark V series boards TCEB and TCTG, both of which can be repaired or replaced at AX Control. The DS200PTBAG1A protective terminal module should be relatively well protected under its standard ordinary printed circuit board coating layer, which is the basic protection against daily wear and tear.
