Manufacturer: General Electric
Series: Mark V
Part number: DS200QTBAG1A
Product type: RST terminal board
The GE RST terminal board DS200QTBAG1A has 2 terminals, each of which can accommodate 72 signal cables. It also includes a 40-pin connector. The ID of the 40-pin connector is JFF. It is also populated with 1 serial connector. The GE terminal board DS200QTBAG1A is also equipped with a 34-pin connector. The ID of the 34-pin connector is JGG.
Two wiring terminals support 144 terminal signal cables. Each terminal is connected to a specific signal line for processing. When a new factory board is delivered to your site, it contains information about 144 terminals and provides specific information about the purpose of each terminal. Use this information to know where the signal line is connected. The ID of one terminal is TB1, and the ID of the other terminal is TB2. In addition, each terminal is assigned a number. To identify a specific terminal, first identify the terminal and then the terminal number. For example, TB1-66 is terminal 66 on terminal TB1. Tb2-33 is terminal 33 on terminal TB2.
Once the signal line is connected correctly and the board is operating as required, there is no need to disconnect or connect the signal line to the terminal unless there is a reason to change the way the board is handled. This can occur if the tasks assigned to the drive change or if other conditions change. Before replacing the circuit board, mark the terminal ID and terminal number on the signal cable.
