DS200TCEBG1ACE Protect the terminal expansion board

The DS200TCEBG1ACE protected terminal expansion board features three bayonet connectors, four signal transformers, and a 26-pin connector, as well as four 10-pin connectors and three 20-pin connectors.

Each bayonet connector is labeled JWX, JWY, and JWZ on the board. Users are able to connect to the public bayonet, but must follow the guidelines to ensure security. To attach the bayonet connector to the board, align it with the connector on the board and press it into place.

To disconnect a cable with a bayonet connector, grab the connector with your thumb and one finger while supporting the board with your other hand and pulling hard to disconnect. When replacing connectors, it is best to label the joints for easy positioning and reconnecting to the new board after installation.

Interference occurs when the power cable produces too much energy and is too close to the signal cable. If the signal is not sent or received accurately, the frequency converter will not operate effectively. The airflow cools the components of the drive and increases the interval between components that must be replaced. Make sure to store your hard drive in a cool, clean place.

DS200TCEBG1ACE Protection terminal expansion board main features and connection methods:
Rich interface: Equipped with various types of connectors (bayonets, pins, etc.), you can connect a variety of devices.
Signal isolation: Four signal transformers are used for signal isolation to improve system reliability.
Clear identification: bayonet connectors are marked with JWX, JWY, JWZ for easy identification.
Simple connection: The bayonet connector is easy to insert and remove, but it needs to be aligned and inserted with force.
Safety precautions: When connecting, follow the guide to avoid damaging the device.
Label Importance: You are advised to label the connection points for easy maintenance.