Categories
Categories

IC660BRD024 The I/O module has 32 DC outputs

Sep 23rd,2024 115 Views

Technical specifications for IC660BRD024
Brand GE Fanuc
Series Genius I-O
Part number IC660BRD024
Description Genius GMR source output module
Application Genius Modular redundant output subsystem
Operating voltage 18 to 56 volts DC
Operating current 0.5 to 1.0 amp
Maximum surge current 10.0 amps
Output OFF leakage current 2.0 MA
Comptible Output group T-OUTPUT group and H-output group
Built-in blocking diode Yes
Configure the Genius handheld display
Output points 32 output points


GE Fanuc IC660BRD024 Genius GMR Source output module is a 12/24 volt DC power output module for the T output subsystem. The IC660BRD024 source output module belongs to the T block output group of the Genius Modular Redundancy (GMR) output subsystem. The output subsystem of GMR controls and monitors discrete output loads, which may include H blocks, T blocks, I blocks, 1 opt-1 diagnostics, and Genius redundant output groups. IC660BRD024 Source Output Block Compatible with H-Output and T-Output groups. In the H-Output group configuration, two IC660BRD024 source output blocks are connected in parallel to one side of the load, while the other two drain output blocks are connected to the other side of the load. In a T-Output group configuration, two IC660BRD024 source output blocks are connected in parallel to one side of the load, while the other end of the load is grounded.

The GE Fanuc IC660BRD024 source output block is a 32-point DC source output block with an operating current load range of 0.5 to 1.0 amps and a maximum inrush current rating of 10.0 amps. The total fixed current of the T-Block output group is 16.0 amps and the maximum rated leakage current is 20 microamps. The IC660BRD024 source output module has built-in blocking diodes and feedback resistors at each output point for fault detection and protection against possible system failures when using I/O reverse drive current in H or T output sets. The IC660BRD024 Source Output Block is installed on the bus (the bus connection must match the GMR configuration) and configured with a handheld monitor.