Technical specifications for IC660ELD020
Brand GE Fanuc
Series Genius I-O
Part number IC660ELD020
Product Description 24/48V DC power supply electronic components
Rated voltage 24/48 V DC
The DC power supply requires a typical value of 150 MA and a maximum of 300 mA
Compatible I/O block IC660CBD020
Compatible terminal assembly IC660TSD020
Operating temperature 0 to 60 degrees Celsius
Storage temperature -40 to 100 degrees Celsius
Relative humidity 5% to 95%, no condensation
Weight 1 lb.
The IC660ELD020 Electronics Assembly is a 24/48V DC power I/O module compatible electronic assembly manufactured by GE Fanuc. It is compatible with the IC660CBD020 Current Source I/O Block and its IC660TSD020 terminal assembly. The electronic component consists of a microprocessor unit of an I/O block. It is responsible for performing communication and other computational tasks within the block. The IC660ELD020 Electronics Assembly is designed in such a way that users can easily insert or remove electronic components from the I/O block without interrupting any block configuration. Fault reporting bytes and block diagnostics bytes are reserved for reporting EEPROM failures in electronic component modules.
The IC660ELD020 Electronics Assembly operates in a temperature range of 0 to 60 degrees Celsius and can withstand relative humidity of 5 to 95 percent. It has microprocessor-based circuitry that connects I/O modules to input and output devices. It helps to configure blocks for redundancy. During installation, be sure to check the compatibility of the electronic component assembly with the I/O block and terminal assembly to ensure normal operation. This electronic component can be replaced with a compatible version without removing the field wiring. Before replacing the module, make sure to disconnect the power supply of the block. To prevent injury, do not touch the connector pins during the removal process. The IC660ELD020 electronic assembly can be easily removed by unscrews the retentors at the bottom and top of the I/O block. It is recommended to use a handheld monitor to correctly configure installed or replaced electronic assembly modules.
