Technical specifications for IC693ACC303
Brand GE Fanuc
Series Series 90-30
Part number IC693ACC303
Type EEPROM card
Storage capacity 32 km
Approximately 1 minute and 35 seconds transfer time
Compatible component micro PLC handheld programmer
Supported PLC models 340, 341 and 351
Functionality reads, writes, or validates data for configuration and program logic
Write protected. Yes.
PLC operation mode program, protection and data
The IC693ACC303 memory card is an EEPROM memory card that is used with programmable logic controllers manufactured by GE Fanuc. Supported micro handheld programmers are available through the GE Series 90-30 and they are used for a variety of applications in different industries. The IC693ACC303 EEPROM memory card can be used to read, write or verify data required for program logic or device tuning. GE Fanuc PLCS using this memory card work in program mode, protected mode or data mode, depending on the requirements of the application at hand. The IC693ACC303 memory card has a storage capacity of 32 KB and can be used in combination with models marked with the following numbers: 340, 341 and 351.
The IC693ACC303 memory card is equipped with a very useful write protect switch, which is located in the memory slot to the left of the programmable logic controller that hosts it. These PLCS are connected via 2 meters or 6 feet of standard cable and come with a 42-key keyboard to make operation simple. The IC693ACC303 memory card is suitable for storing any type of data required for the proper operation of the PLC and simplifies the data transfer process. The data types include different statements related to program logic, registers, and DATA that are necessary to perform a successful configuration for a particular application. The transmission time is approximately 1 minute and 35 seconds. The main purpose of the card is to transfer program logic and configuration from one device to another.
