Technical specifications for IC693PTM101
Brand GE Fanuc
Series Series 90-30
Manufacturer GE Fanuc (ex); Emerson Automation (Current) Emerson Automation (current)
Part number IC663PTM101
Series Series 90-30
Describes the power sensor module
Description Power sensor module
Voltage 10-120 volts AC
Install any series 90-30 baseplate
Current 0-7.5 amps
Compatible with Series 90-30 CPU Any CPU module
The frequency is 35-70 Hertz
Single mode of operation; Three-phase mode; Synchronous monitoring mode
The IC693PTM101 is a power sensor module that is part of Emerson Automation's 90-30 series platform, formerly known as GE Fanuc Automation. The module is mainly used to implement the power analysis and voltage monitoring between the generator and the distribution network. It is a highly intelligent device that can be programmed to operate in single mode, three-phase mode, and synchronous monitoring mode to perform a variety of functions. The module is mounted on the 90-30 series baseplate. It is designed to be connected to current and voltage transformers for data calculation. The module consists of three (3) parts, specifically, a processing module, an interface board, and an interface cable. It can be used in Y or Delta three-phase power systems or single-phase power systems. The IC693PTM101 can be used to accurately measure root mean square (RMS) values of voltage and current, as well as calculate power, power factor, frequency, energy and total demand over a 15-minute period and for three-phase connections. In essence, the module can cover the functions of the power meter, however, by adding operational modes and functions and the ability to connect directly to the PLC, the data integration is simple and can be easily performed. The module can also report data and monitor faults. It can also be used for generator-fixture synchronization functions and to perform demand loss, cost reduction and load reduction requirements. The IC693PTM101 is compatible with all types of 90-30 series PLC cpus. The processor module can be installed on any backboard, whether CPU, expansion or remote backboard, providing maximum flexibility to the user and potentially eliminating long cables.
The IC693PTM101 module is a single-phase power sensor module manufactured by GE Fanuc. It is a 90-30 GE series device widely used in industrial automation. It comes with a processing module, an interface board and an interface cable. It is used to establish a connection between the power sensor and the input transformer. The data generated by this module can be further used by the PLC for reporting, fault monitoring and load/load shedding applications. The IC693PTM101 module has a rated input voltage of 10 to 120 volts AC. Its current rating is between 0 and 7.5 amps. The sensor module has a rated frequency of 35 to 70 Hz and an output of 0. The backplane isolation voltage of the module is 1500 volts. It dissipates heat with a total power of 4 watts. The IC693PTM101 module has enhanced data processing capabilities. It is able to process and process data at an impressive rate, performing data calculations in 20 milliseconds when operating at 50 Hertz and 60 milliseconds when operating at 16.67 Hertz. It has low latency and data processing frequencies between 50 and 60 Hz. All data is measured and analyzed according to the active and reactive power of each phase. The IC693PTM101 module is equipped with predictive diagnostics to provide reports and troubleshoot the entire application process. It can provide information about the module's heartbeat, the voltage present in the phase, the effective phase polarity, the voltage measurement, and the current measurement. The sensor module should be kept away from electrostatic discharge and EMC noise.
