Technical specifications for IC660BBA026
Brand GE Fanuc
Series Genius I/O
Manufacturer Emerson Automation/GE Fanuc (ever)
Part number IC660BBA026
Part number IC660BBA026
Product description analog input module
Nooooo. Enter six (6) analog inputs
Nooooo. Input 6
Each ordinary card counts a group of 6 people
Input accuracy 0.1% of full scale reading
Output signal 4-20 MA
Input resolution 1 microamp
Supply voltage range 18-56 volts DC
Block power 115V AC /125V DC
Communication protocol Genius protocol
Cooling 12 watts
Resolution 1 microamp
Status The LED unit is normal and I/O is enabled
Enter conversion time 16.6ms to 400ms (user optional)
IC660BBA026 belongs to Genius I/O of an independent Block module. It is currently manufactured by Emerson Automation, as GE Fanuc Automation has been acquired by the former. The IC660BBA026 retains its functionality, has six (6) built-in analog input channels, supports current source wiring, and has a resolution of 6μA. As part of the Genius I/O module system, the IC660BBA026 provides an embedded Genius bus communication interface that enables the module to operate independently as a complete remote I/O module, capable of sending and receiving I/O data to the host controller through its own configuration. Its rackless design eliminates the need for a backplane or chassis, providing maximum flexibility for available mounting methods. The I/O module can be mounted face-up or upside-down in the housing, protecting against industrial pollutants in the air. The IC660BBA026 can be configured to connect to the same multipoint network. If used with this module or multiple instances of the same product family, the IC660BBA026 must be 2 inches apart. In addition, the terminating resistor must be installed on the first and last node, spanning terminals Serial 1 and Serial 2. The IC660BBA026 input channels operate without calibration. It comes with software-configurable diagnostics and. These diagnostic functions include low - and high-level alarm reporting, over - and under-range detection, open circuit detection, and internal fault reporting. The module also provides software selection of input conversion times ranging from 16.6 ms to 400 ms.
The IC660BBA026 current source input module is a 6-input analog current source module of GE Fanuc. It can be used to connect with devices that output 4 to 20 mA analog signal current. The Phase B handheld monitor can be used to easily configure modules. Its voltage-to-converter function provides a digital signal based on the received analog current. The user can set the upper and lower alarm limits for each input circuit. The input circuit consists of a 24 volt rated current loop that provides 25 mA of current. The IC660BBA026 Current-Source Input Block has a handheld monitor that prompts alert limits and diagnostic errors. It also has the ability to clear old fault messages from the monitor. The IC660BBA026 current source input block is also compatible with redundant PLC systems, 90-30 series PLCS, 6 series PLCS and 5 series PLCS. Its diagnostic function reports input current levels below 2 mah. The module has a typical thermal drift of 70 PPM per degree Celsius. During installation, make sure to leave 2 or more inches of space between the blocks for proper cooling. The block can be mounted upside down or face up by drilling the appropriate bolt holes. The IC660BBA06 module also comes with a separate installation kit with accessories. A ground terminal called terminal 5 connected to the block case can be used for block security. The power supply of the 115 volt AC or 125 volt DC power supply must be connected to the block's H terminal, and the neutral line must be connected to the N terminal.
