Technical specifications for IC693ACC335
Brand GE Fanuc
Series Series 90-30
Part number IC693ACC335
Number of connectors 2
Pin number 36 per connector
Supported components Programmable controller
Product Type Digital servo shaft terminal board
Voltage 3 volts
Storage temperature range -40 to 85 degrees Celsius (-40 to 185 degrees Fahrenheit)
Servo amplifier support
The IC693ACC335 is a GE Fanuc digital servo shaft terminal board. This terminal board is used to connect the DSM connectors A and B to the corresponding connectors on the GE Fanuc digital servo amplifier. In addition, the servo board provides screw terminal connections for different I/O devices. The GE Fanuc IC693ACC335 terminal board has 2 connectors, each with 36 pins. One of the connectors is labeled as a DSM connector, and users can connect it to DSM devices via a cable. The other connector is labeled a "SERVO" connector, and users can connect it to a GE Fanuc digital servo amplifier. The user requires a servo command cable such as the IC800CBL001 or 002 command cable to make this connection.
If the digital servo shaft does not require any device to connect the IC693ACC335 terminal board to the screw terminal board, the user does not need a terminal board cable or terminal board. In this case, the user can connect the digital servo command cable directly from the digital servo amplifier to the DSM panel. This can be done with either A or B connectors. Users must ensure that they have configured the "OT Limit Sw" setting correctly. This setting must be in the DISABLE position, or DSM will not run. If the IC693ACC335 terminal board is not used for splicing user I/O points (such as origin restricted input), the user must plug the other end of the cable into the front of the DSM panel in a different way. The cable must be inserted into connector A (for servo shaft 1) or connector B (set to servo shaft 2).
