Technical specifications for IC693ACC336
Brand Eton Cutler-Hammer
Series Series 90-30
Manufacturer GE Fanuc
Manufacturer: GE Fanuc (former); Emerson Automation (Current) Emerson Automation (current)
Part number IC693ACC336
Series Series 90-30
Part number IC693ACC336
DIN rail dimensions 125 x 48 x 45 mm
Product Description Auxiliary terminal
Compatible with DSM302 / DSM314
The IC693ACC336 is an auxiliary terminal that is an accessory module for the Emerson Automation Series 90-30 Programmable Logic Controller (PLC) platform, previously manufactured by GE Fanuc. This hardware is specifically designed for the auxiliary terminals of the Motion mate DSM32 and DSM314. It provides remote wiring connections to analog servos and, when configured in analog mode, screw terminals for connecting I/O signals to third-party servo amplifier units and corresponding I/O components. It is also used to connect strobe sensors, origin switches, and over-the-range switches to DSM connectors B, C, or D when operating in analog or digital mode. The screw terminals of the IC693ACC336 have different voltage ratings. Specifically, terminals 16-18 and 34-36 are designed for a maximum voltage of 30 VDC, while the remaining input terminals are rated for 5 VDC. Between the selected I/O terminal and the shield or frame ground, it is recommended to install a metal oxide varistor (MOV) for noise suppression. Recommended wire diameters for terminating input voltages and signals are 14-18 U.S. Wire gauges (AWG) with 5 inch-pounds of tightening torque per terminal. The cable shielding layer of the field device should be connected to the shielding terminal of this auxiliary terminal, marked S. The IC693ACC336 supports DIN rail and panel mounting options. By default, the board is configured for DIN rail mounting. The components of the terminal include a PCB holder or a motherboard with part number UM45 Profil 105.25; 2 Side element with legs, catalog number UM 45-SEFE, with 2 screws. When used for panel mounting, the required assembly is 2 side elements (catalog number UMK 45-SES) with 2 screws and a mounting ear with catalog number UMK-BF.
The IC693ACC336 module is an auxiliary terminal module manufactured by GE Fanuc. This terminal block is commonly used in the DSM314 motion pairing device, which is part of the GE Fanuc 90-30 series PLC system. There are 2 different types of terminal modules for connecting DSM302 devices, they are auxiliary shaft modules and servo shaft modules. The Motion Mate device is connected to a programmable logic controller or PLC via a 36-pin connector. In addition, the DSM302 device can be connected to the PLC via a 1-meter long IC800CBL324 cable or a 3-meter IC800CBL325 cable. Users are advised not to replace these cables with custom versions. GE Fanuc's IC693ACC336 auxiliary terminal module should be connected to the 2 slots on the left side of the motion pairing board, which are Aux Axis 3 and 4. The IC693ACC336 auxiliary terminal module allows DSM302 devices to connect to other auxiliary devices. These devices can be gated detectors, external switches, or incremental orthogonal encoders. The GE Fanuc 90-30 series IC693ACC336 auxiliary terminal module comes with 38 connecting screw terminals. The maximum recommended voltage for I/O terminals 16 to 18 is +30 volts DC, while the maximum recommended voltage for other terminals is +5 volts DC. Two of the 38 screw terminals are marked with the S symbol, one of which must be connected to the ground floor. When users want to install the IC693ACC336 auxiliary terminal module, they have 2 options. It is ideal for DIN rail mounting bases in the following sizes: 125 x 48 x 45 mm. When installing the terminal module, you can use the panel for conversion.
