Technical specifications for IC693MDL330
Brand GE Intelligent Platform /GE Fanuc
Series Series 90-30
Part number IC693MDL330A
Product type output module
Rated voltage 120 to 240 V AC
Output voltage range 85 to 264 V AC
Output 8
Isolation 1500 volts between field side and logical side
The maximum inrush current per cycle is a 20
Minimum load current 100 MA
Maximum output voltage drop 1.5 volts
Each point outputs a current of 2
The IC693MDL330 module is an output module and product of GE Intelligent Platforms/GE Fanuc. It belongs to the 90-30 series. It has a rated voltage of 120 to 240 volts AC and a current of 2 amps. The module has 4 output points in each of the 2 isolation groups, for a total of 8 output points. Two commons in the group are not connected to the IC693MDL330 module. Thus, each group can run on a completely independent AC supply phase, but they can also run on the same power supply. Each set is equipped with a protective fuse, each common end is rated at 5 amps, and each output has an RC buffer to protect it from the transient electrical noise of the power line. The module has an output voltage range of 85 to 264 volts AC, a frequency of 50 to 60 Hz, and a maximum current of 2 amps per point. At 40 degrees Celsius, the maximum current of each group is 4 amps.
The GE Fanuc IC693MDL330 module provides a high level of inrush current (approximately 10 times the rated current and a maximum of 20 amps per cycle, so the output is best suited for controlling incandescent and inductive loads). It has a minimum load current of 100 mA. The IC693MDL330 module does not support DC power, the user needs to provide AC power for the load connected to the output. The module has an LED indicator that shows the "ON" and "OFF" status of each point. In addition, it has 2 horizontal rows with 8 green leds each, with an additional red LED placed between the 2 rows. The eight leds above are labeled A1 through A8 and are used to indicate the output status. If the fuse is blown, the red "F" LED will light up.
