Technical specifications for IC693MDL742
Brand GE Fanuc
Series Series 90-30
Manufacturer GE Fanuc
Manufacturer GE Fanuc; Emerson Automation (Current) Emerson Automation (current)
Part number IC693MDL742
Product description Discrete output module
Series Series 90-30
Product Type Digital I/O
Number of channels 16 (16)
Part number IC693MDL742
Compatibility General Electric Fanuc 90-30
Nooooo. Group number two (2)
Discrete output module with integrated Electronic Short Circuit Protection (ESCP)
Rated voltage 12/24 V DC
Nooooo. Number of channels per group 8 (8)
Nooooo. Number of output groups two (2)
Peak module current consumption 130 MA
The IC693MDL742 is a 90-30 series module. The module is specifically a discrete output module with integrated electronic Short Circuit Protection (ESCP). The module supports a positive logic cabling configuration and offers an output voltage range of 12-24 VDC, +20%, -15%. Again, its maximum output current rating is 1 amp per point; Maximum 50 amps per set when operating at 4 degrees Celsius and 60 amps per set at 3 degrees Celsius. The IC693MDL742 is installed on the 90-30 series baseplate. It occupies one slot and can be installed into any empty slot except for the specified installation location for power, CPU, and dedicated modules. There is no specific limit to the number of module instances allowed. The actual limit depends on the host processor's supported I/O capacity, memory size, and available backboard slots. It can be used to power loads such as motor starters, solenoid drive devices, indicators, relays and similar devices. It comes with a separate channel indicator to describe the energized state of the output channel. The module's embedded Electronic Short Circuit Protection (ESCP) is designed to monitor the public signals of each group. If a short circuit is detected, the "F" LED lights up to indicate a short circuit. In addition to status indications, ESCP protects the board from damage. When all outputs are powered, the backplane power consumption of this module is 130 mA. The typical response time of the output channel is 2 ms (maximum). The module generates a surge current of 5.2 amps for a duration of 10 ms, while the off state leakage current is up to 1 mA.
The GE Fanuc IC693MDL742 module is a 12 to 24 volt DC positive logic Electronic Short Circuit Protection (ESCP) output module. The IC693MDL742 module provides 16 output points, divided into 2 groups of 8 each. Each group has a common power output terminal. The public signals of each group are monitored electronically. When a short circuit occurs, the red LED on the IC693MDL742 module lights up and the output in the group is turned off. This red LED is located between rows of green leds that provide status updates for all individual output points. The short circuit protection function on the IC693MDL742 module does not protect individual output points from exceeding their rated current, but it will protect the module board in the event of a short circuit. After triggering, the 12 to 24 volt DC module power supply needs to be removed to reset the electronic short circuit protection in the IC693MDL742 module. There are two short circuit protection circuits on the module, one output point for each group. The C693MDL742 module is designed for positive logic features. Output current ratings are 1 amp per point, 50 amps per set at 4 degrees Celsius, and 3 amps per set at 60 degrees Celsius. The IC693MDL742 module has a maximum current consumption of 130 mA. The module has a surge current of 5.2 amps and a duration of 10 milliseconds. The maximum output voltage drop is 1.2 volts. The maximum response time for both off and on is 2 milliseconds. The relative humidity (non-condensing) around the module should be maintained between 5% and 95%.
