Technical specifications for IC693MDL750
Brand GE Fanuc
Series Series 90-30
Part number IC693MDL750
Product Type Digital I/O
Output point 32
LED indicator No
The output connects to a 50-pin connector
Rated voltage 12/24 V DC
Module current consumption 21 ma
The peak current output per point is 0.3 amps
Peak common-mode output 2 amps
Product life cycle status * Discontinued/obsolete
The IC693MDL750 module is a 32-point I/O module. It is part of the GE Fanuc family of digital I/O modules designed for use with the 90-30 series of programmable logic controllers. The IC693MDL750 module can be installed in any slot on the 90-30 series programmable controller, which has a 5 - or 10-slot baseboard. There is no LED indicator on the module. The output device can be connected from the output circuit via a 50-pin connector installed on the front of the IC693MDL750 module. The output characteristics of the IC693MDL750 module are compatible with a wide range of user devices, such as motor starters and indicators. The power supply for the user device must be provided by the user. The IC693MDL750 module is rated at 12 to 24 volts DC and is a negative logic output module. A total of 32 output points were divided into 4 groups of 8 each. Each group has 2 common pins.
The IC693MDL750 module absorbs current from the user load to the negative power bus or the user common end, so the IC693MDL750 module has a negative logic characteristic. The IC693MDL750 module draws a maximum current of 21 MA from the 5-volt DC rated bus on the PLC backplane (all outputs are turned on). The maximum output current at each point is 0.3 amps. At 140 degrees Fahrenheit, the maximum output current per common area is 2 amps. The peak output voltage drop is 0.24 volts. GE Faunc recommends storing unused IC693MDL750 modules at ambient temperatures of -40 to 185 degrees Fahrenheit. A housing with IP 54 protection rating should be used to house the baseplate with the IC693MDL750 module.
