Technical specifications of IC693MDL916
Brand GE Fanuc
Series Series 90-30
Manufacturer GE Fanuc; Emerson Automation (Current) Emerson Automation (current)
Part number IC693MDL916
Series Series 90-30
Product Type Digital I/O
Part number IC693MDL716
Compatibility GE Fanuc 90-30 Programmable controllers
Product description Relay output module
Output point 16
Number of channels 16 (16)
The IC693MDL916 is a relay output module that is part of the GE Fanuc series 90-30 programmable logic controllers. The module is A single slot wide module with sixteen (16) individually isolated Type A or normally open (N.O.) contacts. The module has a maximum rated output current of 4 amps per contact and can operate at AC and DC voltages, specifically 5-125 VDC / 5-250 VAC. The IC693MDL916 is a single-slot module that can be installed on a 90-30 series baseboard. It occupies a single slot and supports running as both local and distributed I/O components. Install as many IC693MDL916 modules as you need, limited only by the I/O capabilities, memory capacity, and available mounting slots of the 90-30 series systems. In addition, the IC693MDL916 can act as a distributed I/O component for modern PAC systems RX3i and RX7i Programmable Automation Controller (PAC) platforms. The power consumption of the IC693MDL916's 5VDC backplane is 300 mA. It requires the use of high-density terminals. With individually isolated contact output, maximum operational flexibility can be achieved by allowing mixing of DC and AC signals. The maximum switching frequency for each contact output channel is 20 cycles per minute. This module provides a DIP switch to configure the module's response when the CPU is converted to Stop mode. In addition, the default mode of the module set through the DIP switch must be similar to the configuration created in the programming software. The connectors compatible with this module are IC694TBBx32 or IC694TBSx32.
GE Fanuc Series 90-30 IC693MDL916 output module is a 16-point relay output module. It provides 16 Type A relays for controlling the load connected to the module output. The IC693MDL916 output module can be used with GE Fanuc Series 90-30 PLC or GE PACSystems RX3i systems. The IC693MDL916 output module can be used with different terminals, including extended spring, conventional spring, extended box and conventional box terminals. The DIP switch on the back of the IC693MDL916 output module can be used to change the default mode to Hold Last State mode or to activate the Force OFF function to force power off the module. After the module is removed from the backplane, the DIP switch configuration can be performed. A separate numbered LED is provided on the front of the module to indicate the status of the module output. The rated power consumption of the IC693MDL916 relay output module is 150 mA for 24 volts DC in the backplane and 300 mA for 5 volts DC in the backplane. Field-to-backplane isolation is 250 V AC continuous and 1550 V AC for 1 minute. Output current is a minimum of 10 MA per point, 4 amps for 5 to 250 volts AC, 4 amps for 5 to 30 volts DC, 200 mA for 125 volts DC, pilot load of 2 amps per output, and load of 2 amps per output. The maximum switching frequency is 20 cycles per minute. The DIP switch on the module determines the stop mode output operation on the CPU and determines when the CPU is unable to communicate with the module. The default mode of the output set through the DIP switch must be the same as the default mode configured through the software configuration process.
